Print approval, Material, Flexcap flc quicklock radius coping – Flex FLC Coping User Manual
Page 25: Quantities
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FLEXCAP FLC QUICKLOCK RADIUS COPING
TAPERED VERSION
IMPORTANT!!!
MUST INDICATE PROPER RADIUS CONDITION BY
CIRCLING APPROPRIATE OUTSIDE FACE
PROVIDING A RADIUS
THE RADIUS MAY BE PROVIDED
IN ONE OF TWO METHODS:
1.) THE ACTUAL KNOWN RADIUS IS
OR
2.) FIELD CONDITION MEASUREMENTS
NOTE: REFER TO ATTACHED WORKSHEET
MIDPOINT OF
STRAIGHT EDGE
INSIDE
FACE
MIN. 2 1/4" (57 mm)
MAX. 6" (152 mm)
(914 mm)
LENGTH OF
STRAIGHT EDGE
NOTE: CHECK MEASUREMENTS ALONG ENTIRE RADIUS.
DETAIL A
MIN. 3" (76 mm)
MAX. 6" (152 mm)
%"(10mm) SPACE
PROVIDED FOR
VUALL VARIATION
MOTF^" -- Concealed splice plates are provided with factory
‘ applied dual non-curing sealant strips.
- Fabrication of radius is furnished utilizing a non-penetrating
quicklock joint, then factory sealed watertight.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by:
_____________________________
Date; _______________ __________
MATERIAL:
. 24 Ga. (.65 mm) Steel
. .040" (1.01 mm) Aluminum
. .050" (1.27 mm) Aluminum
. .063" (1.60 mm) Aluminum
Other_________________
Color:
Finish:
QUANTITIES:
.Lineal Feet 4'-0" (1.22 m) Lengths
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800^969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD BY: SAK
SHT.# OF
DWG# 28011-3481
p: 800-969-0108
f: 610-916-9501
print approval
95