Left inside "t" miter, Print approval, Quantities – Flex FLC Coping User Manual
Page 19: Inside "t" coping miters, Right inside "t" miter, Material
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSIDE "T" COPING MITERS
RIGHT INSIDE "T" MITER
INSIDE FACE
SPECIFY
WALL SIZE
SPECIFY
WALL SIZE OUTSIDE
FACE
LEFT INSIDE "T" MITER
INSIDE FACE
SPECIFY
WALL SIZE
OUTSIDE
FACE
INSIDE
FACE
SPECIFY OUTSIDE
WALL SIZE
face
SPECIFY
WALL SIZE
INSIDE
FACE
OUTSIDE
FACE
SPECIFY
WALL SIZE
NOTES;
- Concealed splice plates are provided with factory
applied dual non-curing sealant strips.
- Unless otherwise noted, fabrication of miters and accessories are
furnished standard utilizing a non-penetrating quicklock joint,
then factory sealed watertight.
Fabrication will proceed only after receipt of
signed print approval.
Print Approval:
Architect and/or contractor shall verify all
dimensions, sizes and quantities. All
products to be installed in strict accordance
with Flex's printed instructions.
Approved by:
Date:
______
- Welded Miters and Accessories
Check one □ Required (surcharge) □ Not applicable
MATERIAL:
__ 24 Ga. (.65 mm) Steel
_.040" (1.01 mm) Alum.
Color:
_.050"(1.27mm) Alum.
__ .063" (1.60 mm) Alum.
Finish;
Other
QUANTITIES:
Right Inside "T" Miter(s)
Left Inside "T" Miter(s)
PROJECT:
ARCHITECT:
ROOFING CONTRACTOR:
REPRESENTATIVE/DISTRIBUTOR:
Customer Service:
Phone: 800^969-0108
Fax:610-916-9501
DATE: 12/13/10
DRN BY: JJC
CKD
BY:
SAK
SHT.# OF
DWG# 28011-3475
p: 800-969-0108
f: 610-916-9501
print approval
89