Qtr (one touch recording), Monitoring recording, Otr (one touch recording) – Sears 934.5512559 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
QTR (ONE TOUCH RECORDING)
The One Touch Recording function enables you to record a program simply by pressing OTR button on the VCR.
According to the table, simply press OTR button as many times as needed to set the desired recording length. The
channel number to be recorded and recording length will be shown on the display.
NOTE; This function cannot be done by the remote control.
m
Turn on the VCR.
Set the VCR to the channel to be recorded.
Press OTR button.
/
OTR(t;30)
-
SP
V.
________
/
Recording starts immediately when the OTR button is
pressed, at least two times whether if you are watching
the same or a different channel. The recording length
will be determined by the number of times you press
OTR button.
PUSH(ES)
DISPLAY
LENGTH
1 push
0:00
0:00
2 pushes
0:30
30 minutes
3 pushes
1:00
60 minutes
4 pushes
1:30
90 minutes
5 pushes
2:00
120 minutes
6 pushes
2:30
150 minutes
7 pushes
3:00
180 minutes
8 pushes
3:30
210 minutes
9 pushes
4:00
240 minutes
10 pushes
4:30
270 minutes
11 pushes
5:00
300 minutes
12 pushes
5:30
330 minutes
13 pushes
6:00
360 minutes
14 pushes
6:30
390 minutes
15 pushes
7:00
420 minutes
16 pushes
7:30
450 minutes
17 pushes
8:00
480 minutes
18 pushes
0:00
0:00
• Each time you press OTR button, you will extend the recording time by 30 minutes at a time up to 8-hours (or
to the end of the tape).
• When OTR button is pressed 18 times, the VCR will switch to the Stop mode immediately and the VCR power
will be turned off.
• To stop the OTR operation, press STOP button.
• The recording length time remaining is indicated on the display as the recording is started.
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning, is 8
hours using T-160 (or 6 hours using T-120).
• The TV that is connected to your VCR may be turned on or off during OTR recording.
MONITORING RECORDING
* •
If you set the TV channel to 3 or 4 channel, press
TV/VCR button so that "VCR"
appears
on the display.
Turn on the TV and set the TV channel to the same
video output channel located on the back of the VCR.
(CH 3 or 4)
• If you connect VCR to TV using AV cord, set your TV
to the VCR mode using TV/VCR button of your TV.
2 9
E N
★ ★ ★ ★ ★ 5C16