Sears 934.5512559 - Manual (Page 30)

PLAYBACK
3a
Turn on the TV and set the TV channel to the same
video output channel located on the back of the VCR.
(CHS or 4)
If a tape is already in the VCR, press PLAY button on
the VCR. Power will turn on and playback will start
automatically. (Direct Button Operation)
3b
Insert a tape. VCR will automatically turn on. Press
PLAY button.
(If the erase-protection tab has been removed, the
VCR will start playback automatically.)
If a tape is already in the VCR, Press POWER button
to turn on, and then press PLAY button on the re­
mote control.
Press STOP button when playback is completed.
AUTO REPEAT PLAYBACK
The VCR has an auto repeat function that allows you to repeat a tape indefinitely.
• VCR Power must be on.
• Turn on the TV and set the TV channel to the same video output channel located on the back of the VCR.
(CHS or 4)
• Press the TV/VCR button so that "VCR" appears on the display.
• You must use remote control for this procedure.
Press MENU button on the
remote control. Select item
2(VCR SET UP) with num­
ber buttons.
m
Select item 2(REPEAT
PLAY) with number but­
tons.
"ON" will appear next to
"REPEAT PLAY".
1 TMEfl pnOOBAMKMNO
2 VCRSETUP
9 INITIA1.IZE
TO EXIT THE REPEAT PLAY MODE
Repeat steps [1] and [2]. "ON" will then disappear from
the menu.
1 TAPE SELECT -T130
2 REPEAT PLAY
3 RENTAL
Repeat playback will start
automatically.
Note: Once you select the repeat play mode, it stays in
effect even after you turn off the VCR.
-SO- EN
*****
5CI6