One-piece doors – Sears 139.53971SRT User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They appiy to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag
screws (not provided) to the top of the door.
NOTE: The door bracket may be installed on the top
edge of the door If required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3116“ pilot holes and substitute 5l16”x1-1l2" lag
screws (not provided) to fasten the bracket to the
door.
25