Canon SCANFRONT 220 - Manual (Page 55)

4-13
Chapter 4 Web Menu (Administrator Mode)
Passive Mode
Uses passive mode to send transmissions to the FTP
server.
IMPORTANT
Use passive mode when normal communication with the FTP
server cannot be established. However, be aware that
communication may not be possible if the network is not
functioning properly.
[OK] button
Registers a new FTP server with the specified parameters.
Address type: Shared folder
This option registers a folder shared publicly on the
network.
Name
Enter the name to display on the scanner.
Computer Name (Host Name)
Enter the name of the computer containing the publicly
shared folder.
Folder path
Enter the path to the subfolder that you want to register as
the name of the shared folder.
[Browse] button
Shows a list of computers connected to the network for
you to specify a shared folder.
Hint
You can display the shared folders using the following
procedure.
1. After entering the computer name, user name, password,
and domain/workgroup, click [Browse]. Access the computer
containing the publicly shared folder.
2. Specify any subfolder from the displayed computer and click
[OK].
IMPORTANT
• If you click [Browse] without entering the user account
information, only computers and workgroups within the same
network address will display.
• When displaying workgroups that are not part of a domain,
you cannot display computers or workgroups with different
network addresses.
• Not all workgroups and computers in the network can be
displayed immediately after the ScanFront is started. If some
workgroups and computers are not displayed, wait a few
minutes and then press [Browse].
• A new folder cannot be created in a specified folder via the
Web Menu. If you want to create a new folder, use the
computer set as the FTP server or the address editing
functions of the ScanFront to create a folder beforehand.
User name/Password
Enter the user name and password of an account with the
authority to write data to the shared folder.
Domain/Workgroup
If the computer containing the shared folder is part of a
domain, enter the domain name.
IMPORTANT
• If the computer containing the publicly shared folder is part of
a domain, enter the user name and password registered with
the domain, and the domain name.
• If the computer containing the publicly shared folder is not part
of a domain, there is no need to enter a [Domain/Workgroup].
Save Password
Select this check box to save the password to the address.