Onkyo TX-SR601 - Manual (Page 10)

Ftx>nt panel facilities
Input source buttons (DVD, VIDEO 1-4, TAPE,
TUNER, CD, and PHONO (TX-SR701/701E only))
[41]
These buttons are used to select the input source.
Press these buttons to select the input source for the main zone.
To select the input source for the remote zone (Zone 2) or recording
out (Rec Out), first press the ZONE 2 oi- REC OET button, and then
press the desired input source button. The input channel with its
indicatoi' lit red is output to REC OUT and the one with its indicator
lit green is output to ZONE 2.
AUDIO SELECTOR button [42]
Press to select the type of audio input signal.
DIRECT/PURE AUDIO button and indicator
(TX-SR701/701E only) [46, 48]
PHONES jack [44]
This is a standard stereo jack for connecting stereo headphones.
^ REC OUT, ZONE 2, OFF, LEVEL ▼ / A buttons, and
ZONE 2 indicator [60,61]
The REC OUT and ZONE 2 buttons allow you to use the TX-
SR701/701E/601/601E to output to a remote zone (Zone 2) or to
another component for recording (Rec Out).
To turn off the output, press the OFF button. The ZONE 2 indicator
lights when a signal is output to the remote zone (Zone 2). When the
ZONE 2 indicator is off, then either output to the remote zone is
turned off or Rec Out is selected. Press the LEVEL ▼ / A buttons to
enter the mode for adjusting the volume in the remote zone (Zone
2 ). '
Note:
The Rec Out and Zone 2 buttons use the same circuit and therefore
cannot be used at the same time. When REC OUT is selected,
nothing is output to Zone 2. When ZONE 2 is selected, REC OUT
is automatically fixed to SOURCE.
10