Onkyo TX-SR601 - Manual (Page 37)

Listening to Radio Broadcasts
One of the feaiures of the TX-SR701/701E/601/601E that is most
frequently used is its ability to play FM and AM broadcast radio
stations. The TX-SR701/701E/601/601E provides a number of
listening modes perfect for listening to the radio and getting the
most out of your audio system. Also, by presetting radio stations
that you listen to frequently, you can select them easily by pressing
the CH button on the remote controller.
Tuning into a radio station
1. Press the TUNER input source button.
Each time you press the TUNER button, the
input source changes between A.M and FM.
TUNER
Listening to a stereo radio station (FM mode)
When you tune into a radio station, ► TUNED M
indicator appears in the display. If you tune
into an FM station in stereo, then “FM
STEREO” appears. If the signal is weak, it
may be impossible to tune into the station in
stereo. In such a case, press the FM MODE
button on the front panel. The AUTO
indication disappears and the radio station is
output in the monaural mode. To return to
stereo, press the FM MODE button again.
“AUTO” appears. Some inter-station noise
may be heard, but the sound will not cut in and
out as it would if stereo was selected.
2. Using the TUNING A and ▼ buttons
on the front panel, tune into the
station you desire.
Tuned in stereo Auto mode
Band Frequency “FM STEREO"
(Lights red)
The tuner frequency changes in JOO-kHz (or 30-kHz)
increments for FM and lO-kFlz (or 9-kFlz) increments for
AM.
You can press the TUNING A or T button continuously for
moi'e than 0.5 seconds to scan for an FM station in the
direction of the button you pressed (FM auto tuning mode).
After you release the button and a station is received in
stereo, the scanning slops.
The European model allows you to receive RDS broadca.sts.
See page 39 for more information regarding tuning into
RDS broadcasts.
37