Onkyo TX-SR601 - Manual (Page 24)

Connections
AC OUTLETS
The TX-SR701/701E/601/601E is equipped with AC mains outlets
for connecting the power cords from other devices so that their
power is supplied through the TX-SR701/701E/601/601E. By doing
this, you can leave the connected device turned on and have the
STANDBY/ON button on the TX-SR701/701E/601/601E turn on
and off the device together with the TX-SR701/701E/601/601E.
The shape, number, and total capacity of the AC outlets may
differ depending on the area of purchase.
Caution:
Make sure that the total capacity of the components connected to
the TX-SR701/701E/601/601E does not exceed the capacity that is
printed on the rear panel (e.g„ TOTAL 120W).
European and USA and Canadian
some Asian models models
Rl REMOTE CONTROL
The Rl terminal on the TX-SR701/701E/601/601E is for
connecting other Onkyo components equipped with the Rl same
terminal. When a component is connected to the terminal, it can be
operated by the remote controller supplied with the TX-SR701/
701E/601/601E. In addition, when you connect a component to the
Rl terminal, you can also perform the system operations given
below.
Power on/ready function
When the TX-SR701/70IE/601/60IE is in the standby state, if an
Rl-connected component is turned on, the TX-SR701/70iE/601/
601E also turns on and the input source selected at the TX-SR701/
70iE/601/601E automatically switches to that component.
Be aware that this function will not work if the power cord for the -
connected component is connected to the AC OUTLET on the TX-
SR701/70IE/601/601E, or if the TX-SR701/701E/601/60IE has
already been turned on.
Direct change function
When the play button is pressed at an Rl-connected component,
the input source selected at the TX-SR701/701E/60I/601E
automatically changes to that component.
Power off function
When the TX-SR701/701E/601/601E is placed in the standby state,
all Rl-connected components are also automatically put into the
standby state.
Also, if you press the ON button on the TX-SR70i/701E/601/601E
remote controller while the TX-SR70i/701E/601/601E is turned on,
all Rl-connected components (DVD players, CD players, MD
recorders, tuners, etc.) are also turned on.
Dimmer function
The Dimmer function (display brightness adjustment) of the TX-
SR701/701E/601/601E can be used to synchronize the display
brightness on the connected device using the RI connection.
Caution:
If an MD recorder is connected to the TAPE jack on the TX-SR701/
701 E/601/60IE, switch the Input Selector from TAPE to MD (see
page 43).
To connect components using the Rl terminal, simply connect a
remote control cable from this Rl terminal to the Rl terminal of
the other component. An Rl remote control cable with a 1/8-inch
(3.5-mm) miniature two-conductor plug comes with every cassette
tape deck, compact disc player, MD recorder, and DVD player that
has an RI terminal.
• When performing operations with Rl-connected components
using the RI system, do not use the remote zone (Zone 2).
• Foi' remote control operation, the audio connection cables must
also be connected.
• If a component has two RI terminals, you can use either one to
connect to the TX-SR701 /701E/601/601E. The other one can be
used to daisy chain with another component.
• With Onkyo DVD players, you can enter the pre-program code
so that you can operate the DVD player directly with the remote
controller without connecting the Rl terminals (see page 67).
24