Conair Hopper Temperature Controller UGD031 - Manual (Page 11)

1
Introduction
I n t r o d u c t i o n l 1 - 5
H o w t o U s e t h e L o c k o u t D e v i c e
CAUTION: Before performing maintenance or repairs on this product, you should disconnect and lockout electri-
cal power sources to prevent injury from unexpected energization or start-up. A lockable device has been pro-
vided to isolate this product from potentially hazardous electricity.
Lockout is the preferred method of isolating machines or equipment from energy sources. Your Conair product
is equipped with the lockout device pictured below. To use the lockout device:
1 1
Stop or turn off the equipment.
2 2 Isolate the equipment from the electric power. Turn the rotary
disconnect switch to the OFF, or “O” position.
3 3 Secure the device with an assigned lock or tag. Insert a lock or tag
in the holes to prevent movement.
4 4 The equipment is now locked out.
WARNING: Before removing lockout devices and returning switches to the
ON position, make sure that all personnel are clear of the machine, tools
have been removed, and all safety guards reinstalled.
To restore power to the heater, turn the rotary disconnect back to the ON position:
1 1 Remove the lock or tag.
2 2 Turn the rotary disconnect switch to the ON or “ I ” position.
ON
O
OFF
ON
O OFF
ON
O OFF