Conair Hopper Temperature Controller UGD031 - Manual (Page 83)

B l o w e r I n s t a l l a t i o n a n d
M a i n t e n a n c e
This addendum will assist you in installing and maintaining your HAD blower.
By following the general instructions presented, you will prolong the life of the
equipment, while preventing unexpected downtime.
R e c e i v i n g
All shipments are F.O.B. It is, therefore, in the interest of the buyer to carefully
inspect all shipments before they are accepted from the freight carrier. Upon
delivery, be sure that all items listed on the bill of lading and packing list
(inserted in the plastic envelope attached to the shipment) have been received.
Partial shipments are sometimes made.
The units are skidded, boxed, or crated to fully comply with rail or trucking
requirements for shipment. Accessories are sometimes shipped separately due
to handling space requirements.
Although all equipment is carefully inspected and prepared for shipment at the
factory, damage to the fan and/or drive parts may occur due to rough handling
during shipment.
Any shortage, breakage, or damage noticed at time of delivery should be indi-
cated to the carrier's representative. Damage noticed after delivery should be
reported to the carrier at once. Request their inspection of the shipment and fill
out a concealed damage inspection report.
A d d e n d u m l A D - 1
✐
Note: This addendum
applies only if you have
purchased a Conair Hot
Air Dryer (HAD).