Oil pressure check – Generac 86640 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Oil Pressure Check
Warm up the engine. Then, shut down and remove the
oil pressure switch, install a direct reading pressure gauge in
the oil pressure switch port..,Start the engine and check oil
pressure with the engine running at no-load condition, i.e., no
electrical loads connected to generator.
Oil Pressgre reading should be approximately 40-46 psi
(2.8-3.2 kg/cm^) at 1860 rpm.
Page 3.1-2
Advertising