Cabletron Systems SPECTRUM FRX6000 - Manual (Page 202)

Bridge Configuration
11-8 Configuring Bridge Ports
2. Drag down to Bridge/LLC2 LAN Interface Table, and release. The
Bridge/LLC2 LAN Interface Table,
Figure 11-3 , will appear.
Figure 11-3. Bridge/LLC2 LAN Interface Table
You can conÞgure the following bridge port parameters (except Interface
Number):
Interface Number
This is a sequential number used to identify the interface; it will be assigned
automatically.
Port
This Þeld corresponds to the LAN Card Number. Enter 0 for an FRX4000 or
SmartSwitch 1800 (for RLP0); enter 0 or 1 for an FRX6000. This number must be
identical to the number entered in the LAN Card Number Þeld (see below).
LAN Card Number
This Þeld speciÞes the LAN Card being conÞgured as a bridge port. Enter 0 for an
FRX4000 or SmartSwitch 1800 (for RLP0); enter 0 or 1 for an FRX6000. This
number must be identical to the number entered in the Port Þeld (see above).
Priority
This Þeld prioritizes the interface for trafÞc within the device; the higher the
number, the higher the priority. This priority has no effect on trafÞc exiting the
device. Priorities are conÞgured on all logical interfaces that use a physical frame