Bridge configuration, Configuring device-level bridging parameters, Chapter 11 – Cabletron Systems SPECTRUM FRX6000 User Manual
Page 195: Conþguring device-level bridging parameters -1
11-1
Chapter 11
Bridge Configuration
About FRX and SmartSwitch 1800 Bridging support; configuring device-level bridging parameters;
configuring bridge ports on frame relay and LAN interfaces
The FRX and SmartSwitch 1800 devices support bridging of LAN trafÞc over
Frame Relay. This bridging support includes:
¥
encapsulation of Ethernet and Token Ring trafÞc (per RFC 1490) for
transmission over Frame Relay
¥
Transparent Spanning Tree (802.1d) bridging
¥
compatibility with Source Route Bridging environments
¥
translational bridging between Ethernet and Token Ring LANs
¥
bridging of IP and IPX trafÞc.
Bridging is supported on Ethernet, Token Ring, and Frame Relay interfaces.
Configuring Device-Level Bridging Parameters
If the FRX4000, FRX6000, or SmartSwitch 1800 is going to support one or more
bridge ports (interfaces), certain device-level bridging parameters must be
conÞgured to deÞne bridge operation.
Using the Bridge ConÞguration window, you can conÞgure the device-level
bridging parameters. To access the window:
1.
Click on
to display the Device menu.
2.
Drag down to Bridge Configuration, and release. The Bridge Configuration
window,
, will appear.