Aiwa XM-M25 - Manual (Page 13)

RECORDING
BASIC RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
ooo
ooo
ooo
ooo
ooo
ooo
(BOO»-
ioo
► TAPE REC/
REC MUTE
Preparation
• Use Type I (normal) tapes only.
• Set the tape to the point where recording will start.
1 Insert the tape to be recorded on into deck.
Insert the tape with the side to be recorded on first facing out
from the unit and the exposed side down.
To start recording with the remote controi
First press 9 TAPE REC/REC MUTE, and then press I
2 seconds.
within
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
INSERTING BLANK SPACE
Insertion of 4-second blank spaces may help you to locate the
beginning of the track on other equipments. This unit can add
blank spaces only when the source is TUNER or AUXA/iDEO.
1 Press
9 REC/REC MUTE during recording or while in
recording pause mode.
on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press II to resume recording.
To insert a blank space of less than 4 seconds, press
9REC/REC MUTE again while is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters the recording pause mode, press
9 REC/REC MUTE
again.
Each time 9 REC/REC MUTE is pressed, a 4-second blank
space is added.
"This unit does not have the fuhction to locate the beginning of track.
Recording cannot be done when TAPE function is selected.
O
<
a
>
5
a
111
a
<
h-
O
z
5
B
s
2 Press TAPE/REV MODE to select the reverse
mode.
To record on one side only, select Z..
To record on both sides, select D or C!I5.
3 Press function (TUNER, AUX/VIDEO or CD) and
prepare the source to be recorded.
To record from a CD. press CD and load the disc.
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
To record from a connected source, press AUX/VIDEO and
play.
4 Press 9 REC/REC MUTE to start recording.
When the selected function is CD, playback and recording
start simultaneously.
/ /I /:
; / ;
;.../
r
To stop recording, press ■.
To pause recording, press II (applicable when the source is
TUNER or AUX/VIDEO). To resume recording, press it again.
To erase a recording
Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing
TAPE/REV MODE.
4 Press AUX/VIDEO and turn the connected equipment off.
5 Press
9 REC/REC MUTE to start the erasure.
ENGLISH
12