Sening the clock, To display the current time, To switch to the 24-hour standard – Aiwa XM-M25 User Manual

Page 17: Setting the sleep timer, 1 press sleep while pressing shift, To cancel the sleep timer, Setting the clock setting the sleep timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLOCK AND TIMER

SEniNG THE CLOCK

CLOCK

SHIFT

1 Press CLOCK while pressing SHIFT on the

remote control and press 11 SET within 4 seconds.

The hour flashes.

;

/ ■/ i / =•

/ i " ■/ i ; ■■

.......................

/ / /i-V

/ ■ ■ ■ ■ ■) / ;

2 Press ■« DOWN or UP to designate the

hour, then press II SET.

The hour stops flashing and the minute starts flashing.

3 Press ◄◄ DOWN or ►► UP to designate the

minute, then press II SET.

The minute stops flashing on the display and the clock starts
from 00 seconds.

To display the current time

Press

CLOCK while pressing SHIFT on the remote controi. The

time is displayed for 4 seconds.

However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press

CLOCK whiie pressing SHIFT on the remote control and

then press ■ within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs
to be reset.

If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.

SETTING THE SLEEP TIMER

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press SLEEP while pressing SHIFT.

■tfissl

1.3

;... /

/... /.... ;■■■■■;

/... ¡""i

.. ) £ ;....... £... ;■.. £............) £ £

Specified time

h I £

C C C:

13

......

£ ■■;

£

LJ

ui

O

ft

UI

S

P

a

SLEEP

2 Within 4 seconds, press ◄◄ or ►► to specify

the time until the power is turned off.

Each time the button is pressed, the time changes between 5

and 240 minutes in 5-minute steps.

To check the time remaining until the power is turned off

Press

SLEEP once while pressing SHIFT. The remaining time is

displayed for 4 seconds.

To cancel the sleep timer

Press

SLEEP twice while pressing SHIFT so that “SLEEP oFF”

appears on the display.

ENGLISH

16

Advertising