Aiwa XM-M25 - Manual (Page 6)

REMOTE CONTRO BEFORE OPERATION
I
Inserting batteries
Detach the battery cover on the rear of the remote oontrol and
insert two size AA (R6) batteries.
0
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
To use SHIFT on the remote control
Buttons © have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the button
while pressing
SHIFT.
To use FUNCTION on the remote control
The
FUNCTION substitutes for the function buttons (TAPE,
TUNER, AUX/VIDEO, CD) on the main unit.
Each time FUNCTION is pressed while power is on, the next
function is selected cyclically.
► PRESET on the remote control
The function is the same as that of on the main unit.
SHIFT
FUNCTION
©
PRESET
POWER
Remote
sensor
PHONES
Function
' buttons
■DEMO
To turn the unit on
Press one of the function buttons (TAPE, TUNER, AUX/VIDEO,
CD). Playback of the inserted disc or tape begins, or the
previously tuned station is received (Direct Play Function).
POWER is also available.
To turn the power off
Press POWER.
DEMO (Demonstration) mode
When the AC cord is connected, the display window
demonstrates the functions of the unit. When the power is turned
on, the DEMO display is overridden by the operation display.
When the power is turned off, the DEMO mode is restored.
To cancel DEMO mode
Press DEMO. The clock display appears. (To set the current
time, see “SETTING THE CLOCK” on page 16.) To re-activate
the DEMO mode, press
DEMO again.
Using the headphones
Connect the headphones to
PHONES jack with a stereo mini
plug (03.5 mm, Vs inch).
No sound is output from the speakers while the headphones are
plugged in.
’ If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
' The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor beside TAPE is exposed to intense light, such as direct
sunlight
' Other remote controls are used nearby (those of a television,
etc.)
5
ENGLISH