Beko 4401 - Manual (Page 10)

Oven-Mounting and Warnings
Things to Pay Special Attention to
Regarding the Electrical Connection
- Have the device’s electricity connected
by a certified electrician.
- This device belongs to the primary
protection class and must be operated
only via a grounded electrical
connection.
- The device must be installed in such a
way as to prevent contact with the
electrical connections.
- If, together with the product, a main
cord is not provided, or if a main cord is
provided without a plug: a circuit breaker
must be used with the product such that
a 3 mm gap stands between all contacts
capable of severing the electricity among
all of the poles on the product.
- During product installation, ensure that
no more than one of its side surfaces, if
necessary, stands close to a high wall or
cupboard. In wall ovens that come with
the pyrolitic cleaning function, a minimum
distance of 30 mm must be left between
the oven’s front panel and furniture or
wall of the building.
- The consituent materials of the
installation cavity must be able to
withstand a temperature of 100 °C. This
is especially applicable to and important
for wooden materials, coverings that
adhere to edges, plastic surfaces,
applied adhesives, paints and polishes.
Furniture in the device’s immediate
vicinity must be able to withstand a
temperature of at least 70 °C.
Matters to Pay Special Attention to
Regarding the Oven’s Installation
Cavity!
- For the furniture cavity dimensions and
the placement of the device, see the
diagram.
- If a drawer is to be located underneath
the device, a separator panel must be
placed between the device and the
drawer.
- Because the device is installed flush
with the back wall, the electrical socket,
except for the device’s mounting area,
must be located in an easily accessible
place.
Matters to Pay Special Attention to
Regarding the Positioning of the Oven
- By pushing the device, insert it fully into
the furniture compartment.
Attention! During insertion, ensure that
the eleotrical cable is not broken or
pinched.
- For air ciroulation, some empty space
must remain between the walls and the
compartment into which the device is
installed. For this reason, prior to
stabilizing/immobilizing the device, try to
center it within the cabinet.
- After positioning the devioe,
stabilize/immobilize it with screws as
shown in the diagram.
- The space between the upper surface
and the device must not be
blocked/occupied by any object.
When removing the oven from the
furniture cavity,
- Disconnect the device’s electricity.
-Unscrew the stabilization/immobilization
screws.
- Remove the device by slowly lifting and
pulling out.
9