Beko 4401 - Manual (Page 19)

Operating the clock/programmer
You should adjust the electronic timer prior
to using the oven. Otherwise your oven will
not operate.
The electrical current for the heating
elements flows through the electronic
timer. The timer must be set in order for
the heating elements to come into
operation.
OOOOGICI
o' S S vif — +
The timer of your oven ;
1. You can adjust cooking durations between
00.00 - 24.00 hours.
2. You may also use it as a chiming alarm
between 00.00 - 24.00 hours.
3. You can run fully-automatic, semi-automatic
and non-programmed (manual) a cooking
programmes. (The heating elements inside the
oven are connected to the electronic timer and
are programmable.)
The following functions are available on your
programmable timer;
* Automatic, semi automatic or manual modes,
* Current time clock display in 24h format,
* Timer alarm that can be used as a minute
minder.
Mn
t::!
- +
: Programming button for warnings
: Cooking period adjustment button
: Cooking terminating time adjustment
button
: Manual adjustment button
(non-programmed cooking)
: Time adjustment buttons
Your oven's electronic timer operates similar
to a normal timer. Your oven's electronic
timer will be reset if the electricity is cut-off.
The electronic timer will run slowly if the
frequency of your supply power is less than
50 Hz. (This malfunction is not due to your
timer. In such cases, you must readjust your
timer).
Please note
* The timer controls the oven-heating element
only and the current time of day must be set
before the oven will function.
* If the timer has been set to an automatic or
semi automatic programme, the daily time
cannot be readjusted, the semi or auto
programme, must be cancelled to do so. See
"How to cancel automatic programme".
How to set the current time of
day
The clock display uses a 24 hour configuration;
so 8:30 pm = 20:30.
* Press and hold "o s buttons at the same
time.
* Press"+" button to increase o r t o decrease
the time.
* Adjust using the "+" o r b u t t o n to set the
current time. If "Auto" flashes, see "How to
cancel automatic programme".
* Release the buttons, the clock will now start.
18 |@)