Beko 4401 - Manual (Page 22)

Maintenance and cleaning
Turn off the main switch off
before cleaning.
Before switching on again ensure that all
controls are in the OFF position.
Wipe over the control panel and knobs, with
a damp cloth and polish with a dry cloth. Do
not use oven cleaners or aerosols, scouring
pads or abrasive powder for cleaning the
plastic knobs as damage will occur. Do not
attempt to remove any of the control knobs
from the panel as this may cause damage
and is a safety hazard.
Oven interior
Remove all trays and the grill from the oven.
Clean the interior with a piece of moist, soapy
cloth. Then, clean it once more with a wet
piece of cloth and let it dry.
Do not use dry powder agents for cleaning.
‘•‘We recommended immediate cleaning of
acidic substances such as oil, lemon etc..
•- Use a damp cloth to clean the interior and
exterior. Never use any sharp instruments,
abrasive household cleaner, or detergents
for cleaning. For hard stains use suitable
washing liquid.
«•Cleaning can be accomplished using a soft
piece of cloth wetted with soapy water or
with commercially available special surface
cleaners and a soft piece of cloth. Especially
use liquid paste or cream type cleaners.
Warning!
Never clean the inside of the oven and
trays with hard brushes, steel pads or
knives. *
*Commercially avaible special cleaners
may be used after carefully reading of
the warning labels written on them. Do
not use cleaning agents containing acid
or chlorine.
^
Catalytic-enamelled models (if
available);
The oven interior of this model is coated with
catalytic enamel. Since the catalytic enamel is
self-cleaning, you do not have to perform an
extra cleaning after the cooking operation.
If your oven
contains a steel
rack; To clean the steel
rack, unscrew the 4
screws. After cleaning,
assemble the steel rack
back to the oven body
again.
y
Steel Cleaning
wool powders abrasive
sponges
Do not use the
above materials to clean ceramic
glass and stainless steel surfaces.
Color change is not due to the change in the
material properties, but rather it stems from
insufficient cleaning of burnt residue that
accumulates on surfaces, abrasion on the
glass surface which is caused by pots and
pans along with the use of improper cleaning
agents.
21 @)