Lowering the heating element warning, Replacing the oven lamp (in models with lamp) – Beko 4401 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lowering the heating element
Warning!
Make sure that the heating element is
sufficiently cool before you start cleaning.
1. Unlock the heating element by
loosening the screw at the seiling of the
oven cavity.
Warning!
Never switch on the heating element or
place any weight on it when the heating
element is in the lowered position.
2.
After cleaning, move the heating
element upwards and screw it back to the
ceiling of the oven cavity.
Replacing the oven lamp
(In models with lamp):
1.
Unplug the power cable.
2.
Then, remove the protective glass cover
of the lamp inside your oven by turning it
counter clockwise.
3.
Then, remove the bulb by turning it
counter clockwise.
4.
After installing the correct bulb obtained
from an Authorized Service, reinstall the
protective glass of the lamp.
For the square-shaped lamp models:
There are 2 square-shaped lamps at right
and left
side of
the oven
inside.
Both
lamps ar(
on and
off at the same time
Replacing the Oven Lamp
Disconnect the appliance from the supply
Take out screws on the side shelve
Take out Lens of the oven lamp by means
of the flat screwdriwer
Replace defective lamp with the new one.
Reinstall lens and side sheelf. Lamp type
is 220-230V, 15/25W E14,T300°C
22 <|5)