Beko 4401 - Manual (Page 7)

Installation and preparation
Electrical connection
^
Before your appliance is connected
to the main electricity supply, check
to ensure that the voltage and the
frequency shown in the data plate
correspond with your power supply.
You can find the rating plate under
the front door. When you open the
door, you can see data plate left
bottom side of the cavity entrance.
Warning!
This appliance must be earthed!
^
A cable without a plug is provided
together with your oven (H05 VV-F
3G 1.5)
Take care to connect as below:
* Brown cable = L (Live)
* Blue cable ^ N (Neutral)
* Green / Yellow cable - E (Earth)
* This product must only be installed
by a qualified electrician eg. local
electricity company to a suitable
double pole control unit with a
minimum contact clearance of 3 mm
in all poles which should be adjacent
to (but not above) the cooker in
accordance with lEE regulation,
Failure to observe this instruction may
result in operational problems and
invalidation of the product warranty.
If the appliance is connected by a
plug, this plug must easily be
accessible after installation (but not
above the hob).
The cable length should be 2 m.
max for isolation safety.
Our company shall not be held
responsible for any damage caused
by utilization of the oven without
proper grounding.
Before applying to Authorized
Service, have the electrical wiring of
your home ready for connection.
I.Open terminal cover with screwdriwer
2.0pen cable clamp
3. Change the cable according to this
schema.
Take care to connect as below:
Brown cable = L (Live)
Blue cable = N (Neutral)
GreenA^ellow cable = E (Earth
4. Fix the cable clamp
5. Close terminal cover
6 (|й)