Recording from a cd or the tuner, To erase a recording, To record from an external source – Aiwa CA-DW635 User Manual
Page 12: Sound adjustment during recording, B ‘el
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING
RECORDING FROM A CD OR THE
TUNER
To erase a recording
1 Insert the tape to be erased into deck 1.
2 Press TAPE.
3 Press • REC to start the erasure.
■ TUNER MODE/
OSC
1
II PAUSE
To record from an external source
You can record the sound from an external source
connected to the AUX/VIDEO jack.
1 Insert the tape to be recorded on into deck 1.
2 Press AUX.
3 Press • REC to start recording.
4 Start to play the connected external unit.
Sound adjustment during recording
The output volume and tone of the speakers or headphones
may be freely varied without affecting the level of the
recording.
• Note that recording is done on only one side of the tape.
• Use Type I (normal) tapes only.
7 Insert the tape to be recorded on into deck 1.
Insert the tape with the side to be recorded on facing
out.
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press CD and load the disc.
To record from a radio broadcast, press TUNER/
BAND and tune to a station.
3
Press # REC to start recording.
► PLAY is pressed simultaneously.
When the selected function is CD, playback and
recording start simultaneously.
To stop recording, press M/± STOP/EJECT on deck 1.
To pause recording, press II PAUSE on deck 1. To
resume recording, press again.
NOTE
If squealing or beating sounds occur when recording an AM
broadcast, press TUNER MODE/OSC, so as to eliminate the
noise.
Each time the button is pressed, the dot light on the display
Is turned on and off.
MODE on the remote control is also available.
O
vol
/ II I
b ‘El
5'"^
The dot light
12 ENGLISH