Setting the clock, T o correct the current time, To switch to the 12/24-hour standard – Aiwa CA-DW635 User Manual
Page 13: Dubbing a tape setting the clock
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLOCK AND TIMER
DUBBING A TAPE
SETTING THE CLOCK
6
3
• Note that recording is done on oniy one side of the tape.
• Use Type I (normal) tapes oniy.
1
Press TAPE.
2
Insert a tape to be recorded on into deck 1 with
the side to be recorded on facing out.
3
Insert a tape to be played into deck 2 with the
side to be played facing out.
4
Press
II
PAUSE then press
•
REC on deck 1
to enter recording pause mode.
► PLAY is pressed simuitaneously.
5
Press DUB SPEED to seiect a dubbing speed.
Hi-DUB is displayed: Dubs at high speed.
Hi-DUB is not displayed: Dubs at normal speed.
6
Press
►
PLAY on deck 2.
II PAUSE on deck 1 is released and recording starts.
To stop recording, press U/± STOP/EJECT on deck 1.
1
.
3
,
2.4
When the AC cord is connected for the first time, the time on
the display flashes.
Set the time as follows while the power is off.
1 Press II SET.
The hour flashes.
/_/ A V
/ II I
I _ i . i I I I
I I - .
u u
* s t
V
I
I
(12-hour standard)
DOWN or ►► UP to designate the
2
Press
hour.
Press 11 SET to set the hour.
The hour stops flashing and the minute starts flashing.
4 Press ◄◄ DOWN or ►► UP to designate the
minute.
5 Press II SET to set the minute and complete
the setting.
The minute stops flashing on the display and the clock
starts from 00 seconds.
T o correct the current time
Press POWER to turn the unit off and press II SET twice.
Then, carry out steps 2 to 5 above.
To switch to the 12/24-hour standard
While the power is off, press the II SET button twice until
the hour flashes and then press ■.
When the display switches, carry out steps 2 to 5 above to
set the clock again.
Ilf the clock display flashes while the power is off
This is caused by a power interruption. The current time
needs to be reset.
If
power is interrupted for more than approximately 12 hours,
all settings stored in memory after purchase need to be
reset.
[luring operation II and ■ on the remote control are also
civailable instead of II SET and ■ PRESET on the main
unit respectively.
ENGLISH 13