Care and maintenance, Specifications, To clean the cabinet – Aiwa CA-DW635 User Manual
Page 16: To clean the heads, Care of discs, Care of tapes, Antenna, Laser, Output, Power consumption
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GENERAL
CARE AND MAINTENANCE
SPECIFICATIONS
Occasional care and maintenance of the unit and the
software are needed to optimize the performance of your
unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution. Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
To clean the heads
When the tape heads are dirty;
- high frequency sound is not emitted
- the sound is not adequately high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a
head cleaning cassette.
Use separately sold dry-type or wet-type cleaning cassette.
Refer to the instructions of the cleaning cassette for details.
Care of discs
• When a disc becomes dirty, wipe the disc from the center
out with a cleaning cloth.
• After playing a disc, store the disc in its case. Do not leave
the disc in places that are hot or humid.
Care of tapes
• Store tapes in their cases after use.
• Do not leave tapes near magnets, motors, television sets,
or any source of magnetism. This will downgrade the
sound quality and cause noise.
• Do not expose tapes to direct sunlight, or leave them in a
car parked in direct sunlight.
FM tuner section
Tuning range
Antenna
AM tuner section
Tuning range
Antenna
87.5 MHz to 108 MHz
Rod antenna
530 kHz to 1710 kHz (10 kHz step)
531 kHz to 1602 kHz (9 kHz step)
Ferrite bar antenna
Cassette deck section
4 tracks, 2 channels stereo
Normal tape: 50 Hz - 12500 Hz
AC bias
Deck 1; Recording/playback head x 1
Erasure head x 1
Deck 2: Playback head x 1
Track format
Frequency response
Recording system
Heads
Compact disc piayer section
Laser
D-A converter
General
Power output
Output
Power requirements
Power consumption
Semiconductor laser {X = 780 nm)
1 bit dual
5 W
-I-
5 W (4 ohms, EIAJ)
FTC rule
4 Watts per channel, Min.
RMS at 4 ohms from 65 Hz to
15,000 Hz, with no more than 1%
distortion
PHONES (stereo minijack)
DC 12 V using eight size 6 (R20)
batteries
AC 120 V, 60 Hz
30 W
Dimensions of main unit (W x H x D)
266 X 303 X 278.5 mm
( I O V
2
X 1 2 x 1 1 in.)
Weight of main unit 4.1 kg (9 lbs. 1 oz.)
Speaker
Type
Dimensions (W x H x D)
Weight
impedance
Allowable max. input
120 mm cone type
27 mm ceramic type
I
198 x 303
X
232 mm
(7
Vs X
1 2 x 9 74 in.)
1.75 kg (3 lbs. 14 oz.)
4 ohms
l o w
x 2
Specifications and external appearance are subject to
change without notice.
COPYRIGHT
Please check the laws on copyright relating to recordings
from discs, radio or external tapes for the country in which
the machine is being used.
1
6 ENGLISH