There is no sound, To reset, Troubleshooting guide f*arts index – Aiwa CA-DW635 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING GUIDE

F*ARTS INDEX

If the unit fails to perform as described in these Operating
Instructions, check the foiiowing guide.

GENERAL

There is no sound.

• Is the AC cord connected properly?
• Was an incorrect function button pressed?

Power is not turned on.

• is the AC cord connected to the unit with old batteries

inserted?
-» Remove all the batteries and disconnect the AC cord.
Then, connect the AC cord again and reset the unit as
stated below.

An erroneous display or a malfunction occurs.

Reset the unit as stated below.

TUNER SECTION

The reception contains noise interferences or the sound

is distorted.

• Is the unit picking up external noise or multipath distortion?

Change the orientation of the antenna or the unit.
Move the unit away from other eiectrical appiiances.

CASSETTE DECK SECTION

The tape does not run.

• Is the deck in pause mode? (-» page 10)

The sound is off-balance or not adequately high.

• Is the playback head dirty? (-> page 16)

Recording is not possible.

• Is the erasure prevention tab on the tape broken off?

(-» page 10)

• Is the recording head dirty? (-» page 16)

Erasure is not possible.

• Is the erasure head dirty? (-» page 16)
• Is a metal tape or Cr02 tape being used?

High frequency sound is not emitted.

• Is the recording/playback head dirty? (-> page 16)

CD PLAYER SECTION

The CD player does not play.

• Is the disc correctly inserted? (-» page 8)
• Is the disc dirty? {-> page 16)
• Is the lens affected by condensation?

Wait approximately one hour and try again.

For instructions on use, refer to the page number indicated.

BAND

DISPLAY

EQ

MODE

0-9,

+ ^ 0

REPEAT

FUNCTION

E!

POWER button ©

□ FUNCTION buttons (CD

O,

AUX

O,

TUNER/BAND 0,

TAPE ®)

■ PRESET button O O O 0

► CLEAR button O Q

II

SET button O O © ©

◄◄ DOWN, ►► UP buttons © O 0 ©

TUNER MODE/OSC, DUB SPEED button © ©
SLEEP button ©

TIMER button ©

± OPEN/CLOSE button O

VOLUME buttons ®

QSURROUND button ®

T-BASS button ©

GRAPHIC EQUALIZER (ROCK, POP, JAZZ) ©

PHONES jack ©
MIC jack 0
MIC VOL control ©

[¡1

Deck operation buttons (•, ►, ◄◄,

M/±,

II)

®

© ®

[| DISPLAY button ©

EQ button ©

MODE button © © 0

0-9, -

h

IO buttons O © 6

REPEAT button ©

BAND button ©

FUNCTION button ©

Buttons on the remote control with the same names as those

on the main unit can be used as well.

To reset

If an unusual condition occurs in the display window or the

cassette decks, reset the unit as follows.

1

Press POWER to turn off the power.

2

Press POWER while pressing ■. Everything stored in

memory after purchase is canceled.

ENGLISH 17

Advertising