To cancel the sleep timer, To record the microphone mixing sound, Sening the sleep timer microphone mixing – Aiwa CA-DW635 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEniNG THE SLEEP TIMER
MICROPHONE MIXING
The unit can be turned off automatically at a specified time,
1
Press SLEEP.
f_ l~i
U L I
VOL
2
Within 4 seconds, press ◄◄ or ►► to specify
the time until the power is turned off.
Each time the button is pressed, the time changes
between 5 and 240 minutes in 5-minute steps.
VOL
1 I I
I LI
To check the time remaining untii the power is turned
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice to turn off SLEEP on the display.
Specified time
time remaining until the power is turned off
nnr-o Tho mmaininn timo ic HiftnlflVPrl fnr 4
2
3
Connect a microphone with a mini plug to the
MIC jack.
Prepare a source to be mixed and play it.
Adjust the volume of the microphone with MIC
VOL and the source to be mixed with VOLUME.
To record the microphone mixing sound
Insert a cassette to be recorded on into deck 1 and press
REC.
NOTE
During dubbing at high speed, the microphone mixing
sound is not recorded.
If a microphone is placed too close to the speaker, a
howling sound (feedback) may be produced. If this
happens, move the microphone away from the speaker or
decrease the main volume.
The use of a unidirectional type microphone is
recommended to prevent howling.
If you press SLEEP while the power is off, the power is
turned on and the sleep timer works directly so that the
unit will be turned off after 60 minutes.
To specify the time until the power is turned off, press
SLEEP once again then press ◄◄ or ►► within 4
seconds.
If the unit is turned off during tape playback, ► PLAY on
the decks will not be released. Press STOP/EJECT
to release ► PLAY.
ENGLISH 15