Aiwa NSX-A909 - Manual (Page 25)

SETTING THE Tl
i
2,3,4
4 Select the duration for the timer-activated period
with ◄◄ DOWN or ►► UP, then press II SET.
-C:
^ CD
12D
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
Prepare the source.
To listen to a CD. load the CD to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
Press POWER to turn the unit off after adjusting
the volume and tone.
® remains on the display after the power is turned off (timer
standby mode).
DC
111
H
Q
Z
<
Z
u
©’
o
The unit can be turned on at a specified time every day with the
built-in timer. PM 1 i;:;i ;l DD
Preparation
Make sure the clock is set correctly.
7 Press CLOCK/TIMER twice to display ©, then
press II SET within 6 seconds.
® is displayed and the hour flashes.
0 PL..PS^
If you press II SET after 6 seconds, another operation may
start.
2 Designate the hour of the timer-on time by
pressing ◄◄ DOWN or ►► UP, then press II
SET.
Repeat to designate the minute of the timer-on
time.
P P M 7:;3D
After you designate the timer-on time, one of the source names
flashes on the display.
3 Press ◄◄ DOWN or ►► UP to select a source,
then press II SET.
• If TUNER (AM or FM) is selected, the band cannot be
selected in this step.
C D
12D
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To check the specified time and source
Press CLOCK/TIMER twice. The timer-on time, the selected
source name and the duration for the timer-activated period are
displayed for 4 seconds.
To cancel timer standby mode temporarily
Press CLOCK/TIMER repeatedly until ® or ®REC disappears
on the display.
To restore the timer standby mode, press CLOCK/TIMER
repeatedly to display © or 0REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
’ Timer playback and timer recording will not begin unless the
power is turned off.
' Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
' MULTI JOG is also available instead of and
* ENTER is also available instead of II SET.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press CLOCK/TIMER repeatedly until 0 TIMER REC flashes
on the display, then press
II SET within 6 seconds. Carry
out the steps of “SETTING THE TIMER" from step 2 and insert
the tape to be recorded on into deck 2 after step 5.
ENGLISH
24