Aiwa Z-L31 - Manual (Page 17)

PROGRAMMED EDIT RECORDIN
!□ □ Q.
O O
o o o
0 0 0
O Q
DISC
Ihf DIRECT
PLAY 1-5
Pt4,5
3,7,
8,9
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
1 Insert the tape into Deck 1.
Insert the tape with the side to be recorded on first facing out
from the unit, and wind up the tape with
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice while pressing
SHIFT on the remote control.
“EDIT” and “PRGM” are displayed.
PRGM EDIT
ipRGMC-00
• When “Al” is displayed, press CD EDIT/CHECK while
pressing SHIFT again.
4 Press numbered buttons on the remote control
to designate the tape iength.
10 to 99 minutes can be specified.
•
►► or MULTI JOG are also available to designate
the tape length.
Tape length Tape side A (front side)
......‘30V00"
Maximum recording
time for side A
5 Press one of DISC DIRECT PLAY 1-5 to select a
disc.
Then, press numbered buttons 0-9 and +10 on
the remote control to program a track.
To select disc 4 or 5 from the remote control, press DISC
DIRECT PLAY 4 or 5 while pressing SHIFT.
Example: To select the 10th track of disc 2, press
DISC
DIRECT PLAY 2, then press +10 and 0.
Remaining Programmed
time on side A track numbers Selected track number
I
H'10 p........... 01’
I
o
H ■.... 2h;;41
Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Press CD EDIT/CHECK while pressing SHIFT on
the remote control to select side B and program
the tracks for side B.
Tape side B (reverse side)
I
J 3B..........30”00
o
z
5
u
o
o
111
m
8 Press CD EDIT/CHECK while pressing SHIFT to
select side A and press # on Deck 1.
flashes for 10 seconds, and then CD play and recording
of edited tracks for the first side start simultaneously. When
the end of the tape is reached. Deck 1 enters the recording
stop mode. After entering the recording stop mode, go to
step 9.
9 Press CD EDIT/CHECK while pressing SHIFT on
the remote control for recording of the second
side.
“B” is displayed.
10 Turn over the tape in Deck 1 and press # to start
recording.
Recording starts. •
To stop recording
Press ■/£ on Deck 1. Recording and CD play stop
simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK while pressing SHIFT
on the remote control to select side A or B, and press ◄◄ or
►>- repeatedly.
Track number Programmed track numbers
■ J ' '
Disc number Program number
To change the program of each side
Press CD EDIT/CHECK while pressing SHIFT on the remote
control to select side A or B, and press ■ CLEAR to clear the
program on the selected side. Then program tracks again.
To clear the edit program
Press ■ CLEAR twice in stop mode so that “EDIT” disappears
on the display.
NOTE
' Recording is inhibited if the erasure prevention tab for the side
of the tape facing out from the unit is broken off.
' Up to 30 tracks can be programmed from any of the inserted
discs.
' “FULL” is displayed if you attempt to program more than 30
tracks.
Program number
ENGLISH
17