Aiwa CX NMA545 - Manual (Page 11)

RADIO RECEPTION
MANUAL TUNIN
■MONO
■TUNER
BAND
When an FM stereo broadcast contains noise
Press MONO on the remote control so that “MONO” appears on
the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that “MONO”
disappears.
To change the AM tuning intervai
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing ►.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
O
V)
3
z
o
p
a
ui
Ü
UI
a
Q
flC
1 Press TUNER BAND repeatedly to select the
desired band.
—► FM —►AM---------
When TUNER BAND is pressed while the power is off, the
power is turned on directly.
2 Press ◄◄ DOWN or ►► UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, ((i®)ll is displayed.
m FM
TUNE
TÜV-áE
To search for a station quickly (Auto Search)
Keep ◄◄ DOWN or ►► UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press ◄◄
DOWN or ►►
UP.
• The Auto Search may not stop at stations with very weak
signals.
ENGLISH
1 1