Basic recordin, 1 insert the tape to be recorded on into deck 2, 3 press • rec/rec mute to start recording – Aiwa CX NMA545 User Manual

Page 16: Inserting blank spaces, Basic recording, R i s 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

RECORDIN<

BASIC RECORDIN

Sound adjustment during recording

The output volume and tone of the speakers or headphones are
freely varied without affecting of the recording.

This section explains how to record from the tuner, CD player, or
external equipment.

'•/OREC/

REC MUTE

Preparation

• Use Type I (normal) tapes only.
• Set the tape to the point where recording will start.
• Note that recording is done on only one side of the tape.

1

Insert the tape to be recorded on into deck 2.

Insert the tape with the side to be recorded on first facing out

from the unit.

•±PUSH EJECT

2

Press function (CD, TUNER or VIDEO/AUX) and

prepare the source to be recorded.

To record from a CD.

press

CD

and load the disc(s).

To record from a radio broadcast,

press

TUNER

and tune

in to a station.

To record from a connected source,

press

ViDEO/AUX.

3 Press • REC/REC MUTE to start recording.

When recording from a connected source, start playback of
the source.

^ ^_^ j_^

r i s 3

==

INSERTING BLANK SPACES

Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER

or VIDEO/AUX.)

1 Press # REC/REC MUTE during recording or while in

recording pause mode.

on the display flashes for 4 seconds and 4-second blank

space is made. Then, the deck enters the recording pause
mode.

2 Press II to resume recording.

To insert a blank space of less than 4 seconds,

press •

REC/REC MUTE

again while is flashing.

To insert blank spaces of more than 4 seconds,

after the deck

enters recording pause mode, press •

REC/REC MUTE

again.

Each time the button is pressed, a 4-second blank space is

added.

About cassette tapes
• To prevent accidental erasure,

break off the plastic tabs

on the cassette tape after recording with a screwdriver or
other pointed tool.

To record on the tape again, cover the tab openings with
adhesive tape, etc.

• 120-minute or longer tapes

are extremely thin and easily

deformed or damaged. They are not recommended.

> Take up any slack in

the tape with a pencil or similar tool

before use. Slack tape may breaker jam in the mechanism.

When the selected function is CD, playback and recording
start simultaneously.

To stop recording,

press ■.

To pause recording,

press

II.

(Applicable when the source is

TUNER or VIDEO/AUX) To resume recording, press it again.

To start recording with the remote control

First press

#/0 REC/REC MUTE,

and then press ►/◄► within

2 seconds.

1 6

ENGLISH

“CANT REC” is displayed if you attempt to record on a tape with
the plastic tabs broken off.

To erase a recording

Make sure the microphone is not connected to this unit.

Turn

MIC MIXING

control to

MIN

(See page 22).

1

Insert the tape to be erased into deck 2 and press

TAPE DECK

1/2

to display “TP 2”.

2

Set the tape to the point where the erasure is to be started.

3

Press •

REC/REC MUTE

to start the erasure.

Advertising
This manual is related to the following products: