Adcom GTP-740 - Manual (Page 16)

a video distribution amplifier to make sure the signal arrives at the display device properly.
Consult your ACCOM dealer for additional information if needed.)
Connect the white “Room 2 ouf jack to the left channel input of the amplifier used to
power speakers in the remote area. Then connect the red “Room 2 out” jack to the
amplifier’s right channel input.
Ball System inputs and outputs:
These connections allow easy interface with ACCOM’s unique “Ball System,” the BOS-
500 home theater controller. Note that the BOS-500 processes video signals only so you
don’t need to concern yourself with any audio connections between it and the GTP-740.
(For additional information, consult the BOS-500 manual.)
Connect the BOS-500’s composite video output to the GTP-740’s
yellow-center “Ball System in" jack. Then connect the BOS-500’s
composite input to the GTP-740’s yellow-center “Ball System ouf
jack.
If you are using the GTP-740 with the Ball System, make sure you’ve
set the Ball System switch correctly.
Tape inputs and outputs:
These connections are designed for a cassette
deck or any other audio recording device with line-
level analog inputs and outputs.
Follow these instructions;
1) Connect the recorder’s left channel analog audio output to the GTP-740’s white “tape
in” jack.
2) Connect the recorder’s right channel analog audio output to the red “tape in” jack.
3) Connect the recorder’s left channel analog audio input to the GTP-740’s white “tape
out” jack.
4) Connect the recorder’s right channel analog audio input to the red “tape out" jack.
15