Adcom GTP-740 - Manual (Page 42)

2 ) Press the room 2 button again. The LED’s in the center of the six front panel analog source
selectors will light to show you that you can route any of those sources to the GTP-740’s
“Room 2” outputs. If one of the six source LED’s blinks, that source is already selected for
room 2 distribution. If no LED blinks, no source is currently selected. {Hole: You cannot
direct a digital source - DVD, digital RF, or digital aux — to the Room
2 outputs.)
3) Choose the source you wish to direct to the room 2 outputs by pushing one of the lighted
source selectors. The LED’s in the other source selectors will go out and the name of the
source you’ve just chosen for room 2 distribution will briefly appear in the information display
window. After five (5) seconds, the display will change to show the room 1 (main) source but
the room 2 LED will still glow, indicating that a room 2 source is now active.
4) You can verify the room 2 source selection any time "room 2” capability is active (i.e., any
time the room 2 LED is illuminated) by simply pressing the room 2 button again. You’ll see
ail six analog source selector LED’s light. The active room 2 source LED will blink and the
name of that source will show in the information display. You’ll have ten (10) seconds to
change the room 2 source by simply pressing any other illuminated source selector.
Setting “Room 2” playback volume
You can change “room 2” volume only by using the remote control. There is no way to adjust
“room 2" playback level from the GTP-740’s front panel alone.
Although you can use the remote to adjust “room 2“ volume while still in the main listening/viewing
area, that does not serve a useful purpose as you wont have an easy way to Judge the remote
location’s volume.
1) Press the remote control's main source selector once. This makes sure the remote is ready
to generate GTP-740 command codes.
2) Press the room 2 button twice to access the room 2 mode.
3) Use the remote control’s volume up/down buttons within ten (10) seconds of pressing room
2. The front panel display will show room 2 level changes as you make them and will then
revert to normal display mode ten (10) seconds after the GTP-740 receives the last volume
adjust command.
Remember that you can construct remote control “macros" to automatically put you in “room 2’
command mode. You should always have a second remote controller in the “room 2" location and
that controller can be easily configured with specific room 2 command streams (those beginning
with a command for main source selection followed by two “room 2" pulses) for easy operation.
4.3 Operating Mode Selection
The GTP-740 features several operating modes — Dolby Digital, Dolby Pro Logic, 5 channel
stereo, several “enhancement” modes, etc. — designed to present music and movie soundtracks
as realistically as possible. In addition, some of these modes add the ability to “custom tailor” the
GTP-740’s spatial presentation to better suit individual tastes.
You’ll need to understand these modes — Dolby Digital, Cinema, Dolby Pro Logic, Symphony
Hall, Stadium, Jazz Club, 5 channel stereo, 2 channel stereo — to get the most out of your GTP-
740.
41