Adcom GTP-740 - Manual (Page 28)

For tuner functions (changing stations, etc.):
1. Press the tuner source selector button. It will flash red.
2. Press the tuning up (or tuning down) function button to change stations. The tuner source selector
wfil flash red to confirm that the function button you’ve selected actually triggers a command. (Again,
use the table to see which buttons are preprogrammed.)
Press the CD source selector first to access preprogrammed commands for ADCOM CD players.
Note: You can program new commands over the preprogrammed commands in tuner and CD if you wish.
However, you cannot program any buttons, even those unprogrammed with GTP-740 command codes,
while you're in main mode. This safety feature assures you that you will always be able to fully enjoy the
GTP-740*s capabilities._______________________________________________________________________
Programming Your Own Commands
You can supplement preprogrammed commands with commands to operate other components. Before
you begin to follow these steps, note the status LED located at the top left comer Just above the remote’s
button panel: It will flash red, orange, or green to signal particular functions as you enter new commands
into your ADCOM remote.
Begin by dedding which source component’s commands you will be transferring to the ADCOM remote.
Then press the appropriate source selector button. For example, if you’re teaching your ADCOM remote
commands for your DVD player, press the DVD source selector first. You can “teach” your remote new
commands for any function button (except backlight) after you’ve selected DVD, VCR, TUNER, V.AUX,
CD,D.RForD.AUX.
1. Place the source component’s remote “head to head” with the ADCOM remote. They should be in line
with each other about 2 to 3 inches apart.
2. Press the ADCOM remote’s appropriate source selector and select/play buttons simultaneously.
Hold both buttons until the statuì LED turns orange and the source selector button glows red. Both
indicators should remain lit.
3. Decide which function button on the ADCOM remote you want to learn a new command. Press it.
The orange status LED will begin to flash and the source selector LED will go out.
4. Find the corresponding button on the source component’s remote. Press and hold it until the status
LED on the ADCOM remote flashes green once and remains green until the button on the source
remote is released. Once the button on the source remote is released, the status LED will start
flashing orange again.
5. Verify that the ADCOM remote has learned the new command by pressing and holding the same
button on the source remote. The ADCOM remote’s status LED should flash green twice and then
go back to steady orange. This indicates successful programming. Release the button on the source
remote.
Repeat Steps 2 through 5 for any other commands you want to teach your ADCOM remote for
that source component.
Save the commands you’ve just programmed into the ADCOM remote by pressing and holding the
appropriate source selector and select/play buttons simultaneously. Hold until the status LED and
source selector LED flash twice and then go out. Repeat these steps for any other source commands
you wish to program.
27