Adcom GTP-740 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
In the SETUP screen, highlight SPEAKER SIZE and press Enter.
You will see:
3.5 SPEAKER SIZE Screen
SPEAKER SIZE
SELECT PRESET: 1
MAIN: LARGE
CENTER: ON
REARS: ON
SUBWOOFER: ON
UNDO CHANGES
DONE
SELECT PRESET should be highlighted. If not, use the Up/Down arrows. The < and > buttons will cycle
through Preset 1, Preset 2, and Preset 3. For the moment, select “1."
Why Different Speaker Size Presets?
Most surround controllers allow only one speaker configuration. This is logical,
since you will rarely switch speakers once your system is installed and calibrated.
However, the GTP-740 provides three presets to ailow you to custom-configure
the same system to optimally reproduce both music and video soundtracks.
For example, if you use your system primarily for music reproduction, you might
configure Speaker Size Preset 1 for Targe” main speakers with the rear channels
and subwoofer off. For video viewing, you will probably want rear speakers and
the subwoofer on. Speaker Size Preset 2 gives you №e ability to quickiy choose
tiiis combination when apprq|}riate. We’ve provided Speaker Size Preset 3 for '
your convenience. Use it as you will.___________________________________________
After selecting the proper Preset, scroil down to MAIN. Use the < and > buttons to select either LARGE or
SMALL. Choose LARGE when your main speakers are full bandwidth designs with good bass capability.
Choose SMALL when your main speakers are smaller *satellite” designs or lack deep bass output. (If
you're not sure what to choose here, your ADCOM dealer will be happy to advise you.)
After you’ve configured your MAIN outputs, scroll to CENTER and choose ON or OFF. For most users,
choose ON if your system has a center channel speaker. However, if you’re configuring a Speaker Size
Preset specifically for two-channel music reproduction, you may want to select OFF.
After you’ve configured your CENTER output, scroll to REAR and choose ON or OFF. For most users,
choose ON if your system has REAR channel speakers. However, if you’re configuring a Speaker Size
Preset specifically for two-channel music reproduction, you may want to select OFF.
Scroll to SUBWOOFER and repeat the process described above: ON activates the GTP-740’s Subwoofer
output, OFF mutes it.
After completing all choices, scroll to DONE and press Enter. This will save the configuration and return
you to the SETUP screen.
36