Adcom GTP-740 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

LD in; Connect the LD player’s S-Video output to the mini-DIN connector under the S-Video

“LD in” label.

VCR in: Connect the VCR's S-Video output to the mini-DIN connector under the S-Video

“VCR in” label.

VCR out; Connect the VCR’s S-Video input to the mini-DIN connector under the S-Video

“VCR out” label.

Video aux in: Connect the source’s S-Video output to the mini-DIN connector under the S-Video

“video aux in” label.

Room 2 output; Connect the video display device to the S-Video mini-DIN output under the

“room 2 out” label.

S-Video monitor outputs: Connect the main monitor or display device to the mini-DIN jack

under the “S-Video monitor 1" label. You may use the “S-Video monitor 2” Jack for
another monitor if desired. Properiy connected, either monitor will then display an
image from a video source or on-screen menu information when appropriate.

Ball System input and output: Connect the BOS-500's S-Video output to the mini-DIN jack

immediately under the “ball sys in" label. Then connect the BOS-500’s S-Video input to
the mini-DIN jack under the “ball sys ouf label.

24

Ball System On/Off switch

This switch controls a “video loop" that enables the GTP-740 to function seamlessly with
ADCOM’s Ball System controller.

For conventional high performance home theater systems, make sure the “ball sys on/off switch
is in the off position. When using the Ball System controller, place this switch in the on position.

25

Remote control connections

Infrared

repeater

IR

mini lack

© © ©

remote sensor

extension

Infrared repeater: These mini-jack outputs transfer command codes received from either the IR

mini-jack or remote sensor extension inputs to an IR repeater located close to other
system components. IR signals received at the GTP-740’s front panel IR receptor are
NOT available at the infrared repeater outputs.

IR mini-jack: This input receives IR command codes from remote sensors.

Remote sensor extension inputs: These inputs receive signals from ADCOM’s XR500II and

SPM500II remote control sensors.

17

Advertising