ADLINK USB-1210 User Manual
Usb-1210, Advance technologies; automate the world
Advertising
Table of contents
Document Outline
- USB-1210
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Getting Started
- 3 Operation & Calibration
- 3.1 Operation
- 3.1.1 Signal Function
- 3.1.2 A/D Conversion
- Analog Input Circuitry
- AI Data Format
- Software Conversion with Polling Data Transfer Acquisition Mode (Software Polling)
- Continuous Acquisition Mode
- Sampling Rate Control with External Conversion Strobe Clock
- Analog Input Triggering
- 3.1.3 Trigger Sources
- Software Triggering
- External Analog Triggering
- External Digital Triggering
- 3.1.4 Trigger Modes
- Post-Trigger Acquisition Mode (no retriggering)
- Delayed-Trigger Acquisition Mode (no retriggering)
- Middle Trigger Mode
- Pre-Trigger Mode
- Post-Trigger or Delayed-Trigger Acquisition Mode with Retriggering
- Gated Trigger
- 3.1.5 Programmable Function I/O
- LVTTL DI/DO
- 3.1.6 Basic Timer/Counter Function
- 3.1.7 General Purpose Timer/Counter Modes
- Mode 1: Simple Gated-Event Counting
- Mode 2: Single Period Measurement
- Mode 3: Single Pulse-Width Measurement
- Mode 4: Single-Gated Pulse Generation
- Mode 5: Single-Triggered Pulse
- Mode 6: Re-Triggered Single Pulse Generation
- Mode 7: Single-Triggered Continuous Pulse Generation
- Mode 8: Continuous Gated Pulse Generation
- Mode 9: Edge Separation Measurement
- Mode 10: PWM Output
- 3.1.8 Isolation
- 3.2 Calibration
- 3.1 Operation
- Important Safety Instructions
- Getting Service