ADLINK USB-1210 - Manual (Page 28)

18 Getting Started
Figure 2-5: Module with Wall Mount Apparatus
2.5 Installing the USB-1210 Module
2.5.1 Connecting the USB-1210 Module
1. Turn on your computer.
2. Connect the USB-1210 module to one USB 2.0 port on
your computer using the included USB cable.
3. The first time the USB-1210 module is connected, a New
Hardware message appears. It will take around 6 sec-
onds to load the firmware. When loading is complete, the
LED indicator on the rear of the USB DAQ module
changes from amber to green and the New Hardware
message closes.
4. The USB-1210 module can now be located in the hard-
ware Device Manager, listed as ADLINK USBDAQ 1210
Device as shown.
WARNING:
The appropriate driver must be installed before you can con-
nect the USB DAQ to your computer system. Refer to
Section 1.9: Driver Support for Windows for driver support
information.