Bonaire Navigator Controller - Manual (Page 10)

Multi-Appliance Navigator Control
Navigator Control Page 10
Navigating the Controls
appliances will be hidden and not displayed on your Navigator Controller,
therefore some menu items shown in this instruction may not appear.
9. SETTING DAY AND TIME
On first power up or reset, the time display will flash 12:00 am and shall
remain so until the user sets the time or it receives a set time command
from another device. The user can set the time with the controller in an
ON or OFF state.
To set the time,
1. Press the SETUP button and it will display the Clock, Program and
Advanced (OFF state only) icons on the display. The Clock icon will
be flashing.
2. Press the ENTER button to select the clock and it will display the
time format
12: h or 24: h . To select the time format, press the
UP/DOWN button and then press the ENTER button as required.
3. The display will then flash the HOURS. Press the UP/DOWN
button to increase or decrease the hours. Press the ENTER button
to set hours.
4. The display will flash the MINUTES. Press the UP/DOWN button to
increase or decrease the minutes. Press the ENTER button to set
minutes.
5. The display will flash the DAY on the top row of the display. Press
the UP/DOWN button to change the day. Press the ENTER button
to select the day.
6. The Navigator Controller will display Clock, Program and Advanced
icons. Press the ON/OFF button (OFF state) or the SETUP (ON
state) button to go to the main display.