Bonaire Navigator Controller - Manual (Page 23)

Multi-Appliance Navigator Control
Navigator Control Page 23
Ducted Gas Central Heating
19. PROBLEM SOLVING
WHAT IF CENTRAL HEATER WILL NOT OPERATE!
Question Y/N Solution
Yes Refer to question 4
1.
Has the unit been run
since installation?
No Check the unit is turned on at the power point and the gas shut off valve
is turned on. If not call the installer to commission the unit.
Yes Refer to question 3
2.
Is the unit installed in a
new home?
No Refer to question 4
Yes Refer to question 4
3.
Has the installer run the
unit?
No Check the unit is turned on at the power point and the gas shut off valve
is turned on. If not call the installer to commission the unit.
Yes Turn the unit off (for more than 2 secs) and then on to reset unit. If the
unit still does not start call for service. (refer to solution 6 for reset
instructions)
4.
Is the set temperature
greater that the room
temperature?
No Increase the set temperature so the thermostat calls for heat.
Yes The heater may be programmed to be OFF. To operate the heater
manually press the MODE button until the Thermo is displayed. Adjust
the room thermostat greater than set temperature.
5.
Is the thermostat in
program mode?
No Adjust the room thermostat greater than set temperature.
Yes Reset the unit. This can be done by:
1. Turn the power OFF (for more than 2 secs) and then ON at the
power point
2. Turn the control to OFF
6.
Has there been a known
power surge?
No Unit should operate normally. If not a service call will be required.
THIS TROUBLE SHOOTING GUIDE IS A REFERENCE ONLY.
FOR SERVICE OR WARRANTY REQUIREMENTS PLEASE REFER TO
THE WARRANTY SECTION OF THIS BOOK