Bonaire Navigator Controller User Manual
Page 20
Multi-Appliance Navigator Control
Navigator Control
Page 20
Ducted Gas Central Heating
3.
Press the ZONE button to toggle a zone open or closed. Repeat to
open or close more zones.
The arrow will display under the
selected zone on the LCD screen that are set to open / on.
4.
Press the ENTER button to exit the Zone setup.
Now the Heater operates only in your selected zones.
PROGRAM MODE
To operate the PROGRAM mode,
1.
Turn the Navigator Controller ON by pressing the ON/OFF
button.
2.
Press the MODE button until the Program icon appears on the
display & press the ENTER button to select.
PROGRAMMING
YOUR
NAVIGATOR
CONTROLLER
Programming your Navigator Controller will save time and energy. Your
heating and or cooling system will only operate when you need it and at
your chosen comfort levels. Determine your most comfortable settings,
program them and let your Navigator Controller do the rest automatically.
PROGRAMMING SEQUENCE
Heater / Dual Cycle Refrigerated Air Conditioning
If you've never programmed your Navigator Controller before (or it’s been
a while) remember it's easiest to program the whole week to the same
settings (by selecting the whole week MON TUE WED THU FRI SAT SUN
day choice) and then program variations for particular days or the
weekend as you become more familiar with programming.
If the Controller exits program mode it may be because you've paused
longer than about 1 minute to make your next choice. All the settings
you've made up to then will be saved. Just switch back to program mode,
scroll through your settings using the ENTER button and carry on from
where you left off. The following is the programming sequence for the
Navigator Controller-
1.
Press the SETUP button and it will display Clock, Program and
Advanced (OFF state only) icons on the screen. Currently Clock is
flashing.
2.
Press the
or
button to select Program and press ENTER.
3.
Press the
or
button to change the day or day group to be
modified (Single Day, Week Days, Weekend or Whole Week).
Press the ENTER button to complete the selection.