Bonaire Navigator Controller - Manual (Page 21)

Multi-Appliance Navigator Control
Navigator Control Page 21
Ducted Gas Central Heating
4. You can set 4 program periods in one single day or day group. To
select the program periods press the or button and press
the ENTER button. (NOTE: Set these program periods
according to the time)
5. The HOURS icon will now be flashing. To set the desired hour
press the or button and press the ENTER button to
proceed. The MINUTES icon will now flash. Using the or
button set the minutes. Press the ENTER button to proceed.
NOTE: If you want to disable a period, set time to “--:--“.
6. The temperature will now be flashing. To set desired temperature
press the
or
button and then press the ENTER button.
You can set the temperature from 10°C to 32°C.
NOTE: If you want set an off period, set temperature to “--”.
7. ZONE will flash at bottom of the display (If switched zones are
installed). ZONE 1 or the current zone will flash.
8. Press the
or
button to select the different zones. Press
the ZONE button to open/close the selected ZONE and arrow will
appear under the selected zone.
9. Press the ENTER button to finish. The Navigator Controller will
display and perform a “Sort” function. After the sorting function the
Navigator Controller will display the next period.
10. Press the SETUP button to go to the main screen.
If you want to make corrections to what you've entered, press the SETUP
button and select program by pressing the or button. Now press
the ENTER button and you'll start the programming sequence again.
Scroll through the program selections by pressing the ENTER button and
change any items as you come to them.
If the unit is running under the Program mode, the user may temporarily
override the programmed settings by setting the temperature and the
zone. The “Override” will flash on the display when you change the
temperature or zone in program mode and this will revert back to standard
programming.