Bonaire Navigator Controller - Manual (Page 27)

Multi-Appliance Navigator Control
Navigator Control Page 27
Dual Cycle Refrigerated Air Conditioning
5. The Navigator Controller measures the room temperature using a
thermostat inside its case. When the room temperature is warmer
than the set temp, the Dual Cycle Refrigerated Cooling unit will
cycle on.
6. The Navigator Controller will run the Dual Cycle Refrigerated
Cooler until it measures temperature 2° below your Set Temp and
turn off the Dual Cycle cooling unit.
7. Press the ON/OFF button to switch the cooler OFF.
8. The Navigator Controller remembers your set temperature setting
and uses it next time you turn it ON.
ZONING
Selecting ZONES only applies if your home is fitted with optional
motorised ductwork dampers (please consult your installer) that allow
opening or closing of each section of ducting.
The Navigator Controller will not display any zones if dampers are not
fitted and set up. Where dampers are fitted, the installer can set your
controller to show only the zones available for use.
In homes with more than one zone, at least one zone must be open at all
times. The default zone is 1 if no other is selected.
To set the open or closed status of a ZONE:
1. Press the ZONE button. ZONE 1 (or the current open zone) will
flash
2. Press or to select the zone you wish to control.
3. Press the ZONE button to set a zone as open (ON) or closed
(OFF). The arrow will appear under the selected zone if the zone
is ON. Repeat to open or close more zones.
23. PROGRAMMING YOUR NAVIGATOR CONTROL
Programming your Navigator Controller will provide energy and time savings. Your heating/cooling system
will only operate when you need it, and at your chosen comfort levels.
Determine your most comfortable settings, program them and let your Navigator Control do the rest
automatically.
USING THE PROGRAMMING SEQUENCE
Refer to Ducted Gas Central Heating Section for PROGRAM MODE and PROGRAMMING YOUR
NAVIGATOR CONTROLLER.