Finish plowing, Rt55 t4i operator’s manual – Ditch Witch RT55 User Manual
Page 90
RT55 T4i Operator’s Manual
Plow - 89
Operation
CMW
Finish Plowing
1.
When installation is complete, move plow swing to neutral.
2.
With vibrator running, lower throttle speed and raise plow to ground level.
3.
Move attachment speed/direction control to neutral.
4.
Swivel seat to the drive position.
5.
Lower backfill blade.
6.
Turn ignition switch to STOP and remove product from plow.
7.
Start tractor, swing plow to center position, and engage swing lock and stow lock.
8.
Raise backfill blade and drive a short distance away from work site.
9.
Shut down tractor. See page 64 for proper shutdown procedures.
NOTICE: Do not operate vibrator when plow is out of the ground. This will cause excessive
vibration resulting in rapid wear, and possible damage to the unit and product being installed.