Ditch Witch RT55 - Manual (Page 94)

RT55 T4i Operator’s Manual
Saw - 93
Setup
CMW
Before First Use and After Replacing Bits
Check Bit Clearance
1. Check that all bits are properly secured.
2. Check that all bit retaining rings are secure.
3. Spin wheel by hand and listen for bits hitting diverters.
4. If bits hit diverters, repeat steps 1-3 to make sure bits are in the proper location and secured at proper
depth.
5. If bits do not hit diverters:
• Set parking brake.
• Fasten and adjust seat belt.
• Start tractor and adjust throttle.
• Raise saw slightly.
• Use attachment speed/direction control to rotate saw slowly. As it rotates, listen for clicking
sounds. If clicking is present, shut off engine and repeat steps 1-4.
Normal Use
1. Fasten and adjust seat belt.
2. Start tractor. See page 62 for start-up procedures.
3. Raise saw and drive to starting point. Move in line with planned trench. See page 64 for correct
operating procedures.
4. Lower backfill blade.
5. Engage parking brake and verify parking brake indicator is on.
6. Move gearbox control to 1 (low).
7. Swivel seat to the desired position.
8. Lower saw to just above ground.
9. Check that saw is in line with planned trench and that tires are pointing straight ahead.
NOTICE: Unless otherwise instructed, all service should be performed with tractor off.