Ditch Witch RT100 - Manual (Page 70)

RT100 Powershift Operator’s Manual
Drive - 69
Start Unit
CMW
1. Fasten and adjust seat belt.
2. Check that speed/direction control and F-N-R lever are in neutral.
3. Move hand throttle to idle.
4. Check that parking brake is engaged.
5. Turn ignition switch to the run position (key on, engine off). Wait for operator’s display to come on.
6. When cold start wait indicator goes off, turn ignition switch all the way clockwise to start tractor.
7. Run engine at half-throttle or less for five minutes before operating tractor. During warm-up, check that
all controls work properly.
IMPORTANT:
• If engine does not crank, check start interlock display. See page 31 for start interlock
information.
• If engine turns but does not start within 10 seconds, allow starter to cool before trying to
start again.
Improper control function could cause death or serious injury. If
control does not work as described in instructions, stop machine and have it
serviced.
To help avoid injury:
• Have machine serviced if warning alarm does not sound.
• Machine will not start if start interlock requirements are not met. See page 31 for start
interlock information.
IMPORTANT: Transmission fluid must warm to operating temperature or tractor will operate
sluggishly.