Echelon LonPoint Module - Manual (Page 14)

2-4 LonPoint Modules and Base Plates
Figure 2.2 LonPoint Interface Module - Typical Rear Panel and Jumpers
Network, power, and I/O wiring is connected to screw terminals located on a Type 1
Base Plate (figure 2.3) or Type 1D DIN Base Plate (figure 2.4), into which the LonPoint
Interface Module is plugged; no wiring is ever connected directly to an Interface Module.
A writing space is provided on the back of the Type 1 Base Plate for recording the date
of installation or other pertinent information. Installers should take care to use a fine-
point (smudge-free) pen.
Type 1/1D and Type 2/2D Base Plates are keyed to prevent accidental insertion of an
incorrect module type. The Type 1 Base Plate (Model 40111) and the Type 1D DIN Base
Plate (Model 48111) will only accommodate Interface Modules and Scheduler Modules.
The Type 2 Base Plate (Model 40222) and the Type 2D DIN Base Plate (Model 48222)
will only accept LPR-1X Router Modules.
In either Type 1/1D or Type 2/2D Base Plates, the associated module is affixed to the
Base Plate by means of two 8-32, 3/8” screws (Echelon 205-0130-01) that are provided
with each module.