Dio-10 digital input/output module firmware, Installing the dio-10 digital input/output module – Echelon LonPoint Module User Manual
Page 77
Installing the DIO-10 Input/Output Modules
6-5
DIO-10 Digital Input/Output Module Software Settings
The software settings of the DIO-10 are described in the LonPoint
Application and Plug-In Guide.
DIO-10 Digital Input/Output Module Firmware
The DIO-10 firmware contains the following function blocks: Digital
Input/Counter function block (2), Digital Output function blocks (2),
Analog function block (2), Digital Encoder function block (2), Type
Translator function block (4), Node Object (1).
See the LonPoint Application and Plug-In Guide for details on those
function blocks.
Installing the DIO-10 Digital Input/Output Module
Installation of the DIO-10 module involves the following steps.
1. Ensure that the Type 1 or Type 1D Base Plate has been wired and installed
correctly.
2. Check for continuity on all network and power wiring. Ensure that the correct
sensors are connected to the correct Base Plate I/O terminals.
3. Make certain that all network channels are terminated with the correct number
and type of Terminator.
4. Insert the DIO-10 module into the Base Plate by aligning the network access
jack on the module with the arrow head on the Base Plate (the arrow should
point in the direction of the jack), and then pressing firmly to ensure that the
module is properly seated in its mating Base Plate connector.
5. The DIO-10 module can be hot-plugged: there is no need to disconnect power
when installing the module. If power is present then the Power LED will
illuminate continuously. If power is not present then the Power LED will remain
off.
6. Securely attach the DIO-10 module to the Base Plate by screwing the two
Echelon 205-0130-01 screws (8-32 [M8], 3/8” [9.5mm]) into the threaded inserts
in the Base Plate. Use approximately 4 lbs. in. (0.5Nm) torque on the screws.
7. Follow the node configuration procedure described in the LonPoint Application
and Plug-In Guide
to configure the software in the DIO-10 module.
8. See Troubleshooting for assistance with improper DIO-10 module operation.