Hanna Instruments HI 120 - Manual (Page 34)

34
Press MODE or from the left keyboard and the instrument will
display the next logged parameter as shown in the table below:
Notes: • If pressing from the left keyboard, the previous logged
parameter will be displayed.
• If in Rel mV RECALL mode regarding the slope, the instrument
will display “----” message on the primary LCD.
• The record number refers to an identification number inside a lot.
Last displayed parameter is “dEL” message on the primary LCD and the lot
number on the secondary LCD.
Notes: • The “LdM” message on the secondary LCD shows that data
has been stored in Log on demand mode.
• Pressing 2nd then SET key, the instrument toggles between lot
number, record number (Log on demand only) or all lots.
• Press CLR to delete the selected lot/record or all lots.
Note: Positions remain free in the Log on demand lot by deleting the last
logged samples or all the lot.
• If “dEL ALL” option was selected, all logged data is deleted and the
instrument returns to measurement mode.
Press RCL at any time to return to measurement mode.
OFFSET Offset value Lot (or record) number
TIME Hour & minutes Seconds
DATE Year Month & day
Parameter Primary LCD Secondary LCD
SLOPE Slope value Lot (or record) number
mV mV reading Temperature