Harmonic Resolution Systems MXR Audio Stand User Manual
Page 11
Install all sixteen screws, eight at each panel block on the second panel, 1/4-20 x
3/4" screws to the brace (see photo 16) until they are fully engaged, but do not
torque the screws at this time. You will want to leave them just loose enough so
that there is a very small amount of play to complete balance of assembly. All the
screws for the brace system will be fully tightened at a later point in the assembly
process. If they are tightened at this time, you may not be able to complete
assembly or it will not be level when complete. You will need to use the Allen
wrench at the location closest to the frame because the T-wrench will hit the frame
preventing screw rotation.
Photo 16
Squaring the MXR Frame - It is now time to torque all of the screws in the two
brace assemblies. We recommend using a long level to complete this process.
Place the long level across the top or bottom of the frame assembly (see Photo 17
& 18) and very slowly make minor adjustments in the second panel until it is level
and square with the first panel.
Photo 17 Photo 18